I noticed two of my modules had "old" listed on the firmware. I updated both modules (Link and WXM) and now list as OK. But I noticed all 4 of my ecotechs are now "missing". I figured I may need to reboot the controller and as is always the case when I fo any sort of firmware update, the controller locks up after a reboot. So a hard boot is needed and everything comes back up. Ecotechs still "missing" I go down stairs and they are all dead. Power them back on and they are no longer synced and after a few minutes they go dead again.
I am figuring the auto firmware update I did is no good, not complete or in some way FUBAR'ed... If I try to do a manual update the apes sits at 0%.
Suggestions?
Bookmarks