I bought the ATK set a few months ago and set it up. I finally got it to work and it was great, Then along came the dreaded update. Not only did that upset everything connected to my energy bars but I have not been able to get the ATK to work since.
First of all it is not recognizing that the FMM is even there. The light is green but it seems the sensors are not recognized either. I have read all the advice on forums but still have not been able to get it to work.
This is my programming on the FMM:
FAllback OFF
Set OFF
If Swx4 OPEN Then ON
If Swx4_2 CLOSED Then OFF
When ON > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
For Pump:
Fallback OFF
Set ON
If Swx4_2 Closed Then OFF
I did not grow up with computers so I have tried to use the wizards for most things. When I try to use the ATK setup It says the FMM is not connected when it clearly is! So it will not progress after that.
Any help is truly appreciated!
This is on Apex classic, I have already replaced the pump.
Bookmarks