Results 1 to 2 of 2

Thread: Need help with Code for ATO and Mixing Tank Reservoirs

  1. #1
    Regular Vistor
    Join Date
    Mar 2018
    Location
    Upstate NY
    Posts
    20

    Need help with Code for ATO and Mixing Tank Reservoirs

    I am looking to write some code for my ATO Reservoir and my mixing tank. My goal is to have my apex notify me when either reservoir is low. Then I can give permission to the system to fill the reservoir. The apex will then stop filling when the reservoir is full and turn outlet off until the next alarm/permission cycle.
    I will control the fill with a low level and high level float switch. There will be a solenoid valve attached to an outlet for the RODI fill tube for each reservoir.

    Will this code work?

    I will have an Alarm set:
    LowLevelswitch OPEN Then ON

    When I receive the Alarm, I will go into Fusion and manually turn the Reservoir Solenoid Outlet to Auto.

    Then

    Reservoir Solenoid Outlet:
    Fallback OFF
    Set ON
    If HighLevelswitch OPEN Then OFF
    When OFF > 002:00 Then OFF


    The highlevelswitch will open when the water is full.
    The lowlevelswitch will open when the level drops too low.

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    That should do the trick.

    You might be an engineer if...You have no life and can prove it mathematically.

Similar Threads

  1. question help with reviewing program for salt station mixing tank
    By docartieg in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 0
    Last Post: 03-24-2022, 18:53
  2. Storage tank ATO code error
    By myk5486 in forum Misc Apex Usage & Programming
    Replies: 3
    Last Post: 06-26-2020, 17:14
  3. ATO Code Review - 2nd time tank crashed
    By robram27 in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 1
    Last Post: 04-06-2018, 11:42
  4. Probes in a mixing tank
    By Muttley000 in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 5
    Last Post: 10-28-2017, 13:00
  5. Could this code work to utilize my DOS as an ATO pump, and How would I add the code?
    By alexx2208 in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 4
    Last Post: 08-17-2017, 08:56

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •