Help with program

[five.five-six]

So, I have this 6105 coming on and off every 13 minutes but when it comes in it’s this giant burst and I’d like it to spool up a little more subtly, like over the course of 10 sec. Is there a way to do that?

Fallback ON
OSC 000:00/013:00/013:00 Then ON
If Output Actenic_Moon = OFF Then OFF
If FeedA 005 Then OFF

[zombie]

Not unless you are running it with a Tunze cable through a variable speed port.

You might be an engineer if...You have no life and can prove it mathematically.

[five.five-six]

It is but it needs to be off when it’s off because my other two 6105s only come on when it’s off

[zombie]

It is but it needs to be off when it’s off because my other two 6105s only come on when it’s off

You can spool it up over 1 minute with a ramp profile instead of ON. The apex treats the outlet state as 0% = OFF and 1%-100% as ON.

You might be an engineer if...You have no life and can prove it mathematically.

[five.five-six]

How would I employ the ramp profile?

I have changed it around a bit but currently I have 2 6105’s running in a gyre configuration and a third one set to blow out detritus for a few minutes every hour. When the 2 gyre pumps come back on after the detritus blow, they come full on and splash a lot.

Thanks

[zombie]

Create a profile with min intensity 0, max intensity 100, and ramp time 1 minute.

Create a virtual outlet

RampTimer
OSC 000:00/013:00/013:00 Then ON

In the tunze put
Set OFF
If Output RampTimer = ON Then profilename
If Output Actenic_Moon = OFF Then OFF
If FeedA 005 Then OFF

You might be an engineer if...You have no life and can prove it mathematically.