Hello all.
I've been using the 0-10v variable speed port to control my Reef Octopus various 4 pump. Everything seems to work okay including the ramp profile I set for it but I noticed that even at 100% it is definitely pumping much slower than it should be. I've even tried removing the ramp profile and just setting it to on and it does the same thing. I have The Reef Octopus controller set to maximum flow but even if I disconnect the variable speed y cable and run my pump at the slowest speed using The Reef Octopus controller, it pushes more flow then at 100% with the variable speed cable plugged in. Am I missing something? I've tested this several times and I definitely need to open my gate to keep up with the flow when not using the 0-10v variable speed port. Anyone else have this issue? Thanks in advance
Bookmarks