I have had the PM2 Module for a couple of years (2-3) now. The conductivity probe works great without issues. Recently the temp probe disappears from the display unit along with being displayed on fusion. The display still list it (Temp_T) but with out the reading. On fusion is just simply disappears. I have replaced it with a new probe, just in case it went bad. I have double checked the firmware for the PM2 Module, which is up to date. If I disconnect the aquabus cable and let it sit for a few minutes and reconnect it, it will usually show back up. Just not all the time.
Is there any suggestions or solutions to this problem that I am having? If so, any advice would be greatly appreciated.
Sent from my iPhone using Tapatalk
Bookmarks