I installed everything as per the instructions but the conductivity probe will not even show as powered up. Could I have a bad probe or could the base unit have a bad input?
I installed everything as per the instructions but the conductivity probe will not even show as powered up. Could I have a bad probe or could the base unit have a bad input?
Please be more clear in your description. I don't understand from your post what problem you are having.
You might be an engineer if...You have no life and can prove it mathematically.
The probe will not show the check mark icons that show it is connected. So I plug it in and then go to cal it but can’t because apex does not show that the probe is connected
Try reseating the connector. It might not be locked in all the way.
You might be an engineer if...You have no life and can prove it mathematically.
Thanks for the help. I tried that many times. Still will not show as connected
There is no checkmark that indicates that a probe is connected. In the Inputs view in APEX Fusion or APEX Local, the presence or lack of a checkmark under the status column indicates whether a given probe port is enabled or not. If using the Inputs view, and a probe port is not enabled, you cannot calibrate that port - the calibrations option is not there unless the port is enabled. So it is really unclear what exactly you are doing. Post a screen shot if you can, and give a more detailed description please.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
FA599D4E-7BF6-488B-B706-679F19987246.jpeg
Look at the salt. All the other probes have checks when connected them
So simple. That worked. Thanks
Bookmarks