Add fs-50 to neptune system works for a few second the goes to zero. then i disconnect fs-50 plug back in same thing read for a few sec. then stop working.. I check the firmware the firmware is
update. plus i clean out the fs-50 Need help
Add fs-50 to neptune system works for a few second the goes to zero. then i disconnect fs-50 plug back in same thing read for a few sec. then stop working.. I check the firmware the firmware is
update. plus i clean out the fs-50 Need help
1. Is the arrow pointed in the direction of flow?
2. Did you configure the port for the correct flow sensor size?
3. Are you running a low flow application that would be less than 30 gph?
You might be an engineer if...You have no life and can prove it mathematically.
Yes the arrows pointing in the right direction. No I didn't configure the right size rrrrrrrr How do you configure for the right size?? I have a Apex classic
How to configure the flow sensor size is covered in the video in the FMK Get Started Guide.
https://www.neptunesystems.com/getstarted/fmk/
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Thanks Russ did the step that the video showed. But No Configuration Options Available?????
After you updated the Apex firmware, did you also update the web pages? If not, that would explain why you do not see any options.
Oops - phone mangled some words - fixed.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
here the million dollar question. How do u update the web page????
Thanks zombie and russ.. Its work now. THANKS ALOT
Bookmarks