Results 1 to 5 of 5

Thread: Getting my MP40's to go to Nutrient Mode during feed A

  1. #1
    Frequent Visitor
    Join Date
    Aug 2013
    Location
    Atlanta
    Posts
    100

    Getting my MP40's to go to Nutrient Mode during feed A

    I'd like my Vortechs to run in Nutrient transport mode while FEED a is running.
    I programmed the advance section to be " If FeedA Then Nutrient"
    But after I upload it - it changes to if Feed A then 000 OFF ....
    I am pretty weak at understanding programming and usually someone out there offers simple solutions...

    Any help would be greatly appreciated.
    Bruce

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Type

    If FeedA 000 Then Nutrient

    You might be an engineer if...You have no life and can prove it mathematically.

  3. #3
    Frequent Visitor
    Join Date
    Aug 2013
    Location
    Atlanta
    Posts
    100
    Thank you. That seems to have done it. It goes into Nutrient mode and says 90% ..... Is this 90% automatic or can I actually set it to a lower amount?

  4. #4
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Quote Originally Posted by bhbbhb View Post
    Thank you. That seems to have done it. It goes into Nutrient mode and says 90% ..... Is this 90% automatic or can I actually set it to a lower amount?
    You set it to whatever you want in the nutrient profile.

    You might be an engineer if...You have no life and can prove it mathematically.

  5. #5
    Frequent Visitor
    Join Date
    Aug 2013
    Location
    Atlanta
    Posts
    100
    Thanks - I need some more advice - the above goes right to Nutrient mode - if I wanted the MP40 to actually shut off for 10 minutes then goes into nutrient mode - how do I change?

Similar Threads

  1. Help! Turn Mp40 Off then feed mode?
    By CoralNerd in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 3
    Last Post: 11-17-2019, 13:59
  2. Help! Feed mode and MP40 speed reduction
    By dcb568 in forum APEX Fusion
    Replies: 2
    Last Post: 05-21-2018, 09:39
  3. Question: I need help programming my MP10 and MP40 for feed mode/ nutrient transport mode
    By Koddie Doo in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 5
    Last Post: 01-08-2018, 16:02
  4. Question: Feed Mode and Vortech MP40 Programming
    By Reefer1 in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 3
    Last Post: 12-05-2017, 13:51
  5. Question: Added a Feed mode to MP40
    By Mpderksen in forum Apex Classic/Apex Lite/Apex Jr
    Replies: 4
    Last Post: 05-22-2016, 17:49

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •