I’ve recently noticed that my 2 MP40s would turn off at different times of the day when placed in the auto switch. I checked out the advanced tab and took a screenshot. Is the middle line causing it and if so what is it saying?
I’ve recently noticed that my 2 MP40s would turn off at different times of the day when placed in the auto switch. I checked out the advanced tab and took a screenshot. Is the middle line causing it and if so what is it saying?
Why are you using OSC for MP40s? You should leave that outlet always ON and use the WXM to control them.
You might be an engineer if...You have no life and can prove it mathematically.
After you wrote that I went back and checked because I was pretty sure I programmed it to work with the WXM module. I found 2 other hidden switches and placed them above to the other ones.
I’m not sure which set are the ones that are actually controlling them now but here’s the advanced tab screenshot for the top set.
The ones that show a percent are the WXM control. The ones you have in manual ON should have the following code so they are always powered up.
Fallback ON
Set ON
You might be an engineer if...You have no life and can prove it mathematically.
Thanks Zombie. I added the Feed line in between. I'm not sure what these 2 other switches were for but I assume I can take them out of my Dashboard and control from the switches that show the percentage (WXM Control).
Bookmarks