I’m a first time Apex user but very experienced with another brand controller. Apex is awesome, so refined.
I wired float switches to the breakout box and the switches respond in my dashboard as expected.
If I put a lamp in the EB8 outlet with the code below it goes on and stays on then turns off when expected as the floats move following the code below. Works great as expected. The problem is that when I use my ATO pump it goes on for a few seconds then off for a few then on, etc...until the floats turn it off for good. Why is it “cycling?” But if I toggle the outlet to ON in Fusion it will stay on and not cycle. Also on a physical switch the pump works fine. The pump is a little giant approx 50 Watts. Any suggestions?
I tried several EB8 outlets and even a separate EB8. All the same thing. So strange.
Fallback OFF
Set OFF
If Sw1 CLOSED Then ON
If Sw2 OPEN Then OFF
I also tried:
Fallback OFF
Set OFF
If Sw1 CLOSED Then ON
and:
Fallback OFF
Set OFF
If Sw1 CLOSED Then ON
If Sw1 OPEN Then OFF
Bookmarks