Today I have two xf250 gyres controlled via two icecap modules. I’m trying to figure out a way to (other then powering the gyres off and having the backup batteries kick in) to run a different program when I’m feeding (during feed mode operation, both pumps running at 20%) then normal operation (BRS-Left and Right Gyre oscillation).
Today I simply have the Feed mode turn the power off to the Gyres which in turn kicks them into battery backup mode (hence running at the preprogrammed 30%). I’d like to have more control over this.
I’m only just now learning about virtual outfputs and am not sure if this is the solution.
Thanks for the help...
Bookmarks