I'd like to ask folks opinions here. Would you suggest using the Percent of the COR pump as a control variable or the Speed of the COR pump as the control variable?
Example:
Skimmer venturi pump config:
Fallback OFF
Set OFF
If Output Cor_6_1 Percent > 40 Then ON
Defer 005:00 Then ON
If Skim_1 OPEN Then ON
If Leak_1 CLOSED Then OFF
If Leak_2 CLOSED Then OFF
Versus:
Fallback OFF
Set OFF
If Output Cor_6_1 Speed > 40 Then ON
Defer 005:00 Then ON
If Skim_1 OPEN Then ON
If Leak_1 CLOSED Then OFF
If Leak_2 CLOSED Then OFF
I believe both of these statements will accomplish the goal, but was wondering if there is a suggested preference, and Why.
Thanks
Bookmarks