I just read another post about doing the same thing when my Feed mode A is pushed have my XF250 move a bit of water around.
https://forum.neptunesystems.com/sho...ation-and-Feed
I would like to try moving a bit of flow around as I have a large overflow box behind my 250G tank. I would like some code to turn on my XF250 when Feed MOde A is on - I would like to start at some percent and move up as don't want water to and food to go over overflow box
So I use IceCap Gyre Interface Module: Alternating Gyre Mode
I used this programming based on this VID http://blog.coralvue.com/icecap-gyre...ing-gyre-mode/
Programming (I will just show my LEFT side as the Right is the SAME)
FEED MODE A - 900 Seconds
XF250-L_2_8 (this is the power) Note I have my ICECAP battery backup on this ICE CAP MOD and Gryro
Fallback ON
Set ON
XF250-L-SPD (this is my SPEED with profile)
If Time 10:00 to 23:00 Then SPD_Day_L
If Time 23:00 to 10:00 Then SPD_Night_L
If FeedA 000 Then OFF
XF250-L-DIR (this is my Variable Direction)
If Time 10:00 to 23:00 Then DIR_Day_L
If Time 23:00 to 10:00 Then DIR_Night_L
If FeedA 000 Then OFF
Profiles - Let me know if you need to see these
Let me know if you need anything thing else
Bookmarks