Looking for programming to use Feed C & D to run Auto Water Change Pump for a fixed amount of time. Feed C for 7200 seconds (2hrs) and Feed D for 18000 seconds (5hrs). Here is a start:
Fallback OFF
Set OFF
If FeedD 000 Then ON
If FeedC 000 Then ON
Looking for programming to use Feed C & D to run Auto Water Change Pump for a fixed amount of time. Feed C for 7200 seconds (2hrs) and Feed D for 18000 seconds (5hrs). Here is a start:
Fallback OFF
Set OFF
If FeedD 000 Then ON
If FeedC 000 Then ON
Using Tapatalk
You need to set your feed times first to the length of time required.
Feed.JPG
Then in your outlet for the water change pump add the code.
Fallback OFF
Set OFF
IF FeedC 000 Then ON
IF FeedD 000 Then ON
Just be sure there isn't any other outlets with either FeedC or FeedD in them as these will change state also.
Exactly the help I'm looking for - thanks for the guidance!
Bookmarks