Help Please with Cor 20 FeedA mode

[ajkdark]

My Cor program

Fallback ON
Set CorUp
If FeedA 005 Then 1

CorUp being a ramp profile from 1 to 100 over a minute. The ramp profile works when the Cor has been turned off.

If I manually select FeedA, the Cor slows down to minimum for 5 minutes and then ramps up.

If I program the Neptune AFS to FeedA, the Cor does not slow down. It runs at 100%.

What am I doing wrong?

Thanks, in advance.

[RussM]

Feed cycles are manually activated only. They cannot be started by programming.

Search the Misc Usage and Programming area for ‘vFeed’. There are countless threads about coordinating pumps and feeder operation.

[ajkdark]

Thanks,

I’ll do some reading.

Cheers.