Results 1 to 2 of 2

Thread: Vortech Status "TEMP"

  1. #1
    Frequent Visitor LobsterOfJustice's Avatar
    Join Date
    Jun 2013
    Location
    Cary, NC
    Posts
    859

    Vortech Status "TEMP"

    Over the past few days I have seen one of my Vortech pumps display the status "TEMP" in red on the fusion dashboard a couple times. The pump seems to be running fine. If I wait a minute and check again the status seems to be back to normal. Any thoughts?
    180g reef with all the bells and whistles

  2. #2
    Regular Vistor
    Join Date
    Dec 2013
    Location
    Luzerne County, PA
    Posts
    45
    Try getting some cool airflow near them and see if it goes away. I had to move mine because they kept getting too warm according to my Reeflink.

Similar Threads

  1. Question: Quick Q - can we rename optical sensor output from "open/closed" to "wet/dry"?
    By BTBarney in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 3
    Last Post: 07-07-2020, 16:49
  2. Help! Fusion not showing "Create Note" or "Log Measurement" tile
    By miahpage in forum APEX Fusion
    Replies: 3
    Last Post: 10-16-2018, 20:57
  3. MP40 Status of "Stall"
    By lamann in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 13
    Last Post: 01-06-2016, 15:43
  4. Help! Vortech MP10 Powers off with Outlet set to "Auto"
    By Chris64 in forum APEX Fusion
    Replies: 4
    Last Post: 03-01-2015, 10:38
  5. Question: Implementing "Vortech Variable Feed Mode" from CRM
    By byron in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 4
    Last Post: 02-08-2013, 16:39

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •