Greetings,
I am using a gravity feed for my ATO and the ATK. I have a SV-1 Solenoid valve on the line going to the float valve. This worked fine for a few months but recently I have noticed the ATO is not filling the tank. Sensors are clean and reading properly. After looking at it further I am getting plenty of flow before the solenoid but only a small drip on the otherside when it is opened. I am thinking there might be some debris in the valve and was able to blow air through it.
Looking for suggestions on either taking it apart to look for obstructions or if anyone has had this issue.
Thanks.
Bookmarks