I'm trying to tweak a my AWC routine a bit. Sump_Drain pumps tank water into my skimmer cup via a spray nozzle that cleans it. It flushes the collection area and I have it timed so that it reliably overflows the neck at the end and rinses it too. Works fantastic, but I could possibly be putting a small amount of very diluted skimate back into the system. I'm probably being overkill but... to eliminate that possibility, I just want to have the Sump_Drain do a couple brief on/off cycles at the start of it's run. To dilute/flush the cup a bit more before it goes into full flush mode. Sorry if this is confusing, I cant think of a good way to describe it and there is a lot of other stuff involved. I think the code should make sense for an expert. I'm pretty sure this is wrong, but kind of stumped for ideas.
Sump_Drain (Outlet)
Set OFF
If Output AWC_Drn_Tst = ON Then ON
If Output AWC_OSC = ON Then OFF (This would be the only new line, it would make a few short off pauses at the beginning of AWC_Drn_Tst)
If Sump_W OPEN Then OFF
If Sump_L OPEN Then OFF
Defer 000:01 Then OFF
Min Time 121:00 Then OFF
When On > 002:00 Then OFF
AWC_OSC
Set OFF
If Output AWC_Drn_Tst = ON Then ON
OSC 000:00/000:05/000:05 Then ON
If Output AWC_OSC_end = ON Then OFF
AWC_OSC_end
Set OFF
If Output AWC_Drn_Tst = ON Then ON
Defer 000:20 Then ON
Think I need a way to turn this back off or maybe another VO?
Bookmarks