My cor doesn’t restart after feed mode a, everything else does, i a have to cancel and push A feed a couple of times and it starts up 100 % straight away , not sure what Iv done
thanks
My cor doesn’t restart after feed mode a, everything else does, i a have to cancel and push A feed a couple of times and it starts up 100 % straight away , not sure what Iv done
thanks
You have to post your code or we have no idea how to help.
You might be an engineer if...You have no life and can prove it mathematically.
7F573119-3D55-4A66-A36F-29A19E053150.pngSorry, here you go
That looks like a skimmer code, not a COR code
You might be an engineer if...You have no life and can prove it mathematically.
36A9D550-2251-4BCE-B2AB-1189430072A4.pngThanks Z , I’m a bit confused, I have 2 tiles for the cor20(, is that right , and if so have both got to have code and do they both have to be the same?
sorrh for all the questions
You should only have one tile for the cor unless you plugged its power supply into an energy bar (if you did that outlet should be set always on). The code for the cor should be something like this
Fallback ON
Set ON
If FeedA 000 Then 1
If FeedD 000 Then OFF
You might be an engineer if...You have no life and can prove it mathematically.
Ok yes it’s plugged into the eb , is this the right way to go ? The tiles look different one has the Graph on it the other not
The one with the graph is the COR and if you hit the list part it will bring you to the advanced window where you can add code like above or you can just use the tasks function to auto generate it. The power supply can go into the wall or an outlet that is always on. Your pick there.
You might be an engineer if...You have no life and can prove it mathematically.
Got it , thanks Z , I’m glad you’re here
Bookmarks