Results 1 to 2 of 2

Thread: ATK

  1. #1
    Regular Vistor
    Join Date
    Jul 2013
    Location
    MA
    Posts
    33

    ATK

    Hi - I am finishing setting up my ATK and am noticing that it is running for about 9 seconds every hour or two. My return pump section that I have the sensors in is 6 x 15.5 x 6. The water level has been fine, but just wanted opinions to see if i should alter the code to have the ATK run less frequently for a longer duration.

    FYI - switch 1 is low, switch 2 is high and switch 3 is leak detection.


    Thanks,
    Joe



    Sent from my iPhone using Tapatalk

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    You can make the min time longer. If you do, I would also make the 4 second defer 10 seconds.

    You might be an engineer if...You have no life and can prove it mathematically.

Similar Threads

  1. Help! ATK 'Error on ATK'
    By cottagereefere in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 2
    Last Post: 01-26-2020, 11:15
  2. Can the ATK be run with the PMUP plugged into a DC24v port instead of powering the ATK with AC?
    By powers2001 in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 7
    Last Post: 11-29-2018, 17:41
  3. Help! ATK PMUP fails to start ATK RELAY just CLICKS
    By AES in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 4
    Last Post: 11-22-2018, 19:36

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •