Results 1 to 6 of 6

Thread: Another cor question

  1. #1
    Frequent Visitor
    Join Date
    May 2017
    Location
    uk
    Posts
    185

    Another cor question

    Sorry for yet another, I’m having trouble with the Iq level, every time I set It for min max it will just stop completely when I press feed , I’m sure it’s to do with code again , I was under the impression that once it was set on with IQ that would be it?
    Thanks guys

  2. #2
    Frequent Visitor
    Join Date
    May 2017
    Location
    uk
    Posts
    185
    FA2F6B0C-A5A7-460B-AA65-097B1B16FDEE.pngOk so I did this and seems to work, is the right way to go about it?

  3. #3
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    It looks like you didn't finish the task. Make sure to move the IQ slider during that stage to where the pump just barely trickles and the max slider set to your desired normal flowrate. Rather than using the wizard and the advanced tab, you are better off using the task generated code or tha advanced view (icon looks like a list) as a starting point which should be something like

    Fallback ON
    Set ON
    If FeedA 000 Then 1
    If FeedD 000 Then OFF

    You might be an engineer if...You have no life and can prove it mathematically.

  4. #4
    Frequent Visitor
    Join Date
    May 2017
    Location
    uk
    Posts
    185
    Thanks Z , what would feed D be for?

  5. #5
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Quote Originally Posted by jamiequ View Post
    Thanks Z , what would feed D be for?
    I always use that set to about an hour for miscellaneous maintenance and manual water changes.

    Personally I use

    FeedA - frozen or pellet feed: pumps slow down, return to 1%, skimmer off 5 minutes after return

    FeedB - acclimate new arrivals. Pumps slow down for 30 min return and skimmer operate normally

    FeedC - coral feed. Return to 1% for 30 min pumps stay normal speed, skimmer off for 5 min after return

    FeedD - general maintenance. Return, skimmer, and wavemakers off for 1 hour.


    You might be an engineer if...You have no life and can prove it mathematically.

  6. #6
    Frequent Visitor
    Join Date
    May 2017
    Location
    uk
    Posts
    185
    That makes sense, thanks Z

Similar Threads

  1. Question: Cor 15 Program question
    By bhbbhb in forum COR-15 & COR-20 Pumps
    Replies: 1
    Last Post: 05-26-2020, 14:57
  2. Two Cor 20 setup question
    By Alexreef in forum COR-15 & COR-20 Pumps
    Replies: 0
    Last Post: 10-12-2019, 04:04
  3. Cor 20 question
    By Rcat7 in forum Pre-Sales Questions
    Replies: 3
    Last Post: 08-31-2019, 13:00
  4. Question: Cor 15 question/issue
    By CRK1 in forum COR-15 & COR-20 Pumps
    Replies: 2
    Last Post: 12-06-2018, 01:11

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •