So my system was down and dry for a while. I finally got it wet this weekend. Set my WAV pumps back in place. Only 1 would show up and the other would not work. No Stall or position error. Just un-responsive. Did a system reboot and second WAV showed up. One was now in a position error and the other in a stall (Right Pump). After going into the classic console /module set up to give them both a kick (Update alarm configuration and set position) the left came online and works fine. Right one still stalled. crammed bump and you can feel it try to start then stop. Took out impeller and gave it a wipe (Both were put away clean) I was able to give that one a kick in the module set up and the stall went away. But still no work work..
Firmware is up to date. Apex is running the latest. Cor15 runs fine on same 1 link. Swapped cables and problem follows the pump.
Anny troubleshooting suggestions would be huge...
Bookmarks