So check this out .....
I have a small powerhead in my sump for the sole purpose of tumbling my Chaeto. At first i had it set to come on with my sump light . Command was IF Fugelight =on then on. it came on just fine . but i did not shut off with the fuge light. so i then just set the pump to cycle on and off as if it were a light. used the same set up as the fuge light. Again it came on just fine but didn't shut off . According to fusion ( which it was set to auto) it was off , but it is on. So apex says its off, program says it should be off but it is still running. Here is the odd part. If i unplug the pump from the power block, then plug it back in it stays off. then i turn it on with fusion, it comes on, turn it off with fusion it stays on , although fusion says it off. Im baffled any one ???
Bookmarks