Task: Power Usage Alarm

[jgrubbs]

When using the Task: Power Usage Alarm, where is the resultant code for the alarm written? I would like to review the various alarms which have been configured and complete the configuration for the missing pumps.

This code is not visible in any of the Email_Alert, SndAlm, EB83, or the Outlet advance configuration pages.

[Member No 1]

You would think it would put the alarm in the email_alarm, does it doesn't

Go to inputs, then on the right side, if an alarm is set, there will be a check mark in the column under the "Bell"
Click on the check mark and you can adjust the alarm parameters there.

[jgrubbs]

Ah, got it, I've seen the checkmark indicating that an alarm existed but, did not consider the Inupts List as the point to track and adjust. Thank you!

[zombie]

This is the exact reason I don't use the task or inputs alarms. The scattered nature makes it way to time intensive to review and edit code. I like it all in one neat place in email_i5

You might be an engineer if...You have no life and can prove it mathematically.

[wwanthony]

This is the exact reason I don't use the task or inputs alarms. The scattered nature makes it way to time intensive to review and edit code. I like it all in one neat place in email_i5

You might be an engineer if...You have no life and can prove it mathematically.

Same here....

[TerraReef]

This is the exact reason I don't use the task or inputs alarms. The scattered nature makes it way to time intensive to review and edit code. I like it all in one neat place in email_i5

Same here! I wish this wasn't hidden in random places.