I hooked up a leak detection sensor to my fmm module. My question is, what code do I use to shut off my return pump if a leak is detected? Thanks in advance..
Sent from my FRD-L04 using Tapatalk
I hooked up a leak detection sensor to my fmm module. My question is, what code do I use to shut off my return pump if a leak is detected? Thanks in advance..
Sent from my FRD-L04 using Tapatalk
Here's the code for my return pump:
If LkCrpt CLOSED Then OFF
If LkSump CLOSED Then OFF
If S2_Flt OPEN Then OFF
The three sensors I'm monitoring are:
LkCrpt = Neptune leak sensor under my carpet
LkSump = Neptune leak sensor in my sump cabinet
S2_Flt = Float switch in my return chamber to sense if the water level drops too low to safely run the pump
I'm running a COR-20. The code I posted above is what I have listed under the "Advanced" tab. That screen in Fusion states "Program statements may be entered here, and will be evaluated last. For example, if you'd like to specify a feed mode, this is the place."
The settings for the COR main screen controls turning the pump on as long as none of the Advanced statements are active. I have tested each of these sensors and they each turn off the pump, but as soon as the problem is cleared up the pump automatically turns back on.
Sorry if this wasn't clear in my original post. I assume a non-Neptune pump would require additional programming to turn it on.
For both the OP and your code, I would reccomend a slightly different approach. There are two ways depending on whether you want self resetting or latching. This filters out noise spikes and ensures the return stays off.
Self Resetting (retries every 2 hours is condition stops)
StopRtn (virtual outlet)
Set OFF
If LkCrpt CLOSED Then ON
If LkSump CLOSED Then ON
If S2_Flt OPEN Then ON
Defer 000:10 Then ON
Min Time 120:00 Then ON
Return & email
(Existing code)
If Output StopRtn = ON Then OFF
Latching (stays OFF until you manually intervene)
StopRtn (virtual outlet)
Set OFF
If LkCrpt CLOSED Then ON
If LkSump CLOSED Then ON
If S2_Flt OPEN Then ON
Defer 000:10 Then ON
Defer 000:03 Then OFF
When On > 000:02 Then ON
Return & email
(Existing code)
If Output StopRtn = ON Then OFF
You might be an engineer if...You have no life and can prove it mathematically.
Im following along. I would also like to set my Leak detection prob on my FMM module to shut off my return pump, and skimmer. Im very new to the apex however this is confusing? Although I'm learning slowly.
I don't understand fully the code above? I do understand just having the return pump and skimmer shut off when the leak detector is in the closed position only turns them on again if say the sensor is removed from the water. Id like to use a visual outlet to turn both off until I actually turn them on by sliding the switch back to On. Id also need to prevent my skimmer from overflowing with some sort of delay? Can someone help me with this? I will label my equipment in hopes someone can give me the code needed.
SUMP RETURN PUMP = RETPUMP_3
SKIMMER PUMP = SKIMMER_2
LEAK SENSOR = LkSump
Bookmarks