I have a 1/2" flow sensor up and running. Unfortunately it keeps sending an alarm
"OzoFlo > 27.5 THEN ON" This line of code does not exist. In the advanced settings I have completely disabled the alerting.
I trigger my alarm based on a virtual outlet that lets things settle down prior to alerting.
OzFlow is the name of the sensor monitoring the amount of water flowing into my ozone reactor. Virtual outlet vHiOzoFlo
Set OFF
If OzFlow > 148 Then ON
Defer 000:45 Then ON
Here is my Email Alarm.
Set OFF
If Error AtoPmp61 Then ON
If SumpHi CLOSED Then ON
If Output vSumpLow = ON Then ON
If Tmp > 85.0 Then ON
If Tmpx8 > 85.0 Then ON
If ORP > 410 Then ON
If ORPx8 > 410 Then ON
If Output vHiOzoFlo = ON Then ON
If OzH2O CLOSED Then ON
If H20Flr CLOSED Then ON
This was working fine until I had to take it all apart because of a leak in my sump.
Thanks for any help or suggestions.
William Anderson
Bookmarks