Hey there, I had a bit of an "OOPS" moment last week. I left the ATO to ON and left the office. Came in the next day and it was running dry (splashing a bit). The tank had enough room to not overflow, so safe there.
When I turn it on now via Fusion the FMM just clicks every 3 seconds. No errors come up. so I'm not 100% sure.
The actual pump does not turn or even attempt to turn. No humming / vibrating either.
Any ideas?
P.S.
I would like to get this one fixed... BUUUUUUT I also have an FMM with the Leak Detection Kit... So I could, worse comes to worse, combine them into one... But I have 3 leak sensors so I guess I would lose out on one of those and have to figure out how to combine them in the Fusion software.
Bookmarks