Results 1 to 4 of 4

Thread: APEX Shows MP-40qd has Stalled

  1. #1
    Regular Vistor
    Join Date
    May 2015
    Location
    San Diego, CA
    Posts
    47

    APEX Shows MP-40qd has Stalled

    Hi,
    My APEX classic dashboard shows "Stalled" next to one of the MP-40qd's running on my tank. The MP40's have been running a while without any problems. In fact, it appears that the MP-40 (with Stalled) is also running. The WXM module status light is on/okay and it appears to be controlling all my MP-40's.
    I have turned off the pump a few times through the dashboard and also manually and the message persists.
    Any thoughts?
    Thanks,
    John

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Is the module firmware for the WXM current? If not try updating and see if it has any effect.

    Sent from my SM-G965U using Tapatalk

  3. #3
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    22,464
    Vortechs do not inform the WXM when a stall has cleared. Disconnect the Aquabus cable(s) from the WXM for a few seconds, then reconnect. Wait a few minutes then check the dashboard.
    Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

  4. #4
    Regular Vistor
    Join Date
    May 2015
    Location
    San Diego, CA
    Posts
    47
    RussM,
    That worked. Thanks!

Similar Threads

  1. Question: WXM with 2 MP 40QD
    By jeff the great in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 0
    Last Post: 11-30-2021, 05:12
  2. Replies: 3
    Last Post: 01-27-2018, 14:41
  3. WAV Stalled
    By [email protected] in forum WAV Powerheads
    Replies: 0
    Last Post: 05-06-2016, 18:35
  4. Stalled?
    By wwanthony in forum WAV Powerheads
    Replies: 2
    Last Post: 09-16-2015, 16:36
  5. Mp-40QD and WXM module set up
    By stumpedin06 in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 3
    Last Post: 03-20-2015, 16:27

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •