Originally Posted by
patricksteward
I have setup APEX mostly successfully but am now running into problems trying to properly setup the FMM for my ATK. ATK was originally in standalone mode and now trying to get it to work through APEX and have now hit several problems.
1. Using Apex.Local on my Mac I have no "task" option to easy setup the ATK. Further no "new module" appears in the dashboard. I see the Sensors (SWx5_1 and 2) and that they point back to the FMM. but nothing else.
2. On my IOS iPad I do have the "task" option, however everything in the center of the Dashboard is greyed out so no access to essentially any control on the power bar through the app.
3. Now both the app and apex.local are telling me that my #2 sensor is "open"
4. I just want to control the FMM through my Apex (ideally even power the ATO pump through the powerbar). But I just don't seem to have the same software options. Everything is up to date firmware.
5. Last question: is there a chart somewhere that actually shows all the APEX inputs on the power bar and their corresponding names in the software (as factory default)?
Thanks!
Bookmarks