Installed an ATK on a customers system today. I can get it to turn on by sliding if to the ON position on fusion with both sensors out of water which is obviously correct. When I submerge both sensors it turns OFF which is correct function.
My question is that when I pull both sensors from water and dry them the pump does NOT kick back on when in AUTO mode on the switch.
When setting it up I read that it will wait an hour before it kicks back on again after it was activated. Is that a correct? I’m no longer at the clients site and won’t be for 2 weeks and want to make sure it is topping off correctly.
Thanks in advance
Sent from my iPhone using Tapatalk
Bookmarks