I'm just setting up my Apex 2016 w/ EB832 power bar, and no additional modules.
The Apex has run through setup, and I can access it locally on my home network.
I do not have any of the 8 'main' plug ports available in the dashboard.
I am only showing VARSPD 1-4 and EMAILALM. Additionally I am showing SW1-6.
If I go to the outputs tab there is also showing SndAlm and SndWrn.
Lastly, if I go to the Modules tab, it shows the EB832_2 with SW rev showing 8 with an OK, and a green check mark under status.
The front panel of both the EB832 and Apex are lit orange.
Any help would be appreciated.
Thanks
Bookmarks