I have a feeling I will have to get this resolved by support but figured I would ask in case someone knew.
I had a PM2 module that was previously hooked up to system and had the Aquabus address of 012. It had a temperature probe connected to it named 'WC_Temp'. The PM2 was disconnected and removed and deleted from the apex. Later a new EB4 was added to system, the new EB4 took the Aquabus address of 012. The AMP 'Probe' on the new EB4 is showing the old PM2 temperature probe name 'WC_Temp' instead of the the traditional Amp name.
To my knowledge there is no way to change amp 'probe' names.
Thoughts?
1.png
2.png
Bookmarks