Would the following be correct if I wanted to run a dosing pump for 5 seconds every 24 hrs?
OSC 000:00/000:05/1439:55 THEN ON
If not, what would be the correct programing code?
Thank you.
Would the following be correct if I wanted to run a dosing pump for 5 seconds every 24 hrs?
OSC 000:00/000:05/1439:55 THEN ON
If not, what would be the correct programing code?
Thank you.
I believe, you can only use 000:000 three digits in the OSC statement. I could be mistaken.
You could use the IF TIME statement along with OSC statement to accomplish this..
If Time 00:01 to 23:59 Then OFF
OSC 000:00/000:05/000:55 Then ON
That give the OSC statement a 1 minute window to run. You can change the time as necessary.
Whoops, close thanks!
Sent from my SM-G955U using Tapatalk
Thank you both for helping out!
Zombie, how did you get so good at this stuff? Next time I’ll just pm you directly!
Thanks again
Rick
Experience and similarity to things I do in my job (I am a protection engineer and do a fair bit of automation).
Dont bother with PM, any PM of a non personal nature I just direct back to the forums anyway so lurkers and new users can benefit from reading threads with a similar issue as theirs.
Sent from my SM-G965U using Tapatalk
Not to worry, it was just a figure of speech. I was stoked to have something I can use without pulling all of my hair out trying to solve.
Thanks again.
Bookmarks