I have 2 WAV powerheads mounted one on left and one on right glass in a new tank Red Sea 350 reefer (approx. 73 gallons of water). I used the task configuration and found some a schema (24h WAV Primary).This configuration never goes much above 60% and with so much power - I am nervous about 60% in this smaller tank.
I have to admit I am completely overwhelmed and confused (despite reading these forums, watching videos, etc). I guess I want one powerhead to inverse the other - I am not sure if I need to set "one point" across the 24 hours to inverse or duplicate this schema on the other powerhead and change every point to inverse.
Understanding powerhead placement and tank inhabitants dictate a lot of configuration - if anyone has a successful configuration or recommendations based on a similar setup - this would be much appreciated.
Bookmarks