Results 1 to 5 of 5

Thread: DOS as AWC

  1. #1
    New User
    Join Date
    Jun 2017
    Location
    Brisbane, Australia
    Posts
    3

    DOS as AWC

    When using the wizard to program the DOS to do AWC the right hand pump runs for about 10mins then turns off, thus causing the sump to receive new water but not remove old water. When switching from auto to on in the dashboard it does the same. Help needed!!

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Quote Originally Posted by Catfish View Post
    When using the wizard to program the DOS to do AWC the right hand pump runs for about 10mins then turns off, thus causing the sump to receive new water but not remove old water. When switching from auto to on in the dashboard it does the same. Help needed!!
    Make sure their programming is identical and that both are set to AUTO.

    Sent from my SM-G965U using Tapatalk

  3. #3
    New User
    Join Date
    Jun 2017
    Location
    Brisbane, Australia
    Posts
    3
    I found that the DOS can only dispense 200ml at a time before taking a 30min break. I have adjusted the amount to change to under 200ml increments. I’ll see if it works out.
    Thanks

  4. #4
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Are you using profiles for AWC? If so, I would not reccomend that. Much better to use the wizard.

    Sent from my SM-G965U using Tapatalk

  5. #5
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    22,463
    The 200ml/30 minutes info tells me that your programming is turning the pump output to ON, rather than activating a DOS profile or running programming by the DOS wizard. You should not be using ON in programming (as in “some command” Then ON).

    I agree with zombie here - For AWC, using the wizard is the preferred thing to do. It’s also the easiest to configure. Using DOS profiles should be reserved for less-common situations when the wizard cannot be used.
    Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

Similar Threads

  1. Question: Using DOS to do AWC
    By Mad_Mardigan in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 0
    Last Post: 09-10-2016, 08:04
  2. DoS and AWC
    By MrsReefK in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 2
    Last Post: 07-28-2016, 13:34
  3. Help! DOS for AWC - need to turn off ATO while running AWC
    By Fanatical in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 10
    Last Post: 05-10-2016, 04:35
  4. AWC with DOS
    By jimbow in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 0
    Last Post: 01-08-2016, 17:21
  5. DOS for AWC
    By hkgar in forum Pre-Sales Questions
    Replies: 2
    Last Post: 03-01-2015, 15:23

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •