I don't see a need for additional VOs; just use the state of the existing VOs for the Gyre instead of the state of the COR; I'd use the same programming as for the COR, with one exception - dealing with the fact that the Gyre doesn't run at 10%:
My original COR programming for herring_fish:
Fallback OFF
Set OFF
If Output Step10_Up = ON Then Step20
If Output Step20_Up = ON Then Step20
If Output Step40_Up = ON Then Step40
If Output Step80_Up = ON Then Step80
If Output Step100_ON = ON Then ON
If Output Step80_Dn = ON Then Step80
If Output Step40_Dn = ON Then Step40
If Output Step20_Dn = ON Then Step20
If Output Step10_Dn = ON Then Step10
I was wracking my brain trying to figure out why I had used non-ramping Ramp profiles to obtain a constant speed/intensity rather than using percentages; then it dawned on me - it was because of a need for logging to facilitate tweaking of the timings induced by the various Defers. If the timings have now been tweaked to satisfaction, then I'd now just use percentage and do away with the Step## profiles.
Revised programming for COR:
Fallback OFF
Set OFF
If Output Step10_Up = ON Then 10
If Output Step20_Up = ON Then 20
If Output Step40_Up = ON Then 40
If Output Step80_Up = ON Then 80
If Output Step100_ON = ON Then ON
If Output Step80_Dn = ON Then 80
If Output Step40_Dn = ON Then 40
If Output Step20_Dn = ON Then 20
If Output Step10_Dn = ON Then 10
Programming for Gyre to operate in lockstep w/ the COR, with the necessary 10%/20% override in the first and last If statements:
Fallback OFF
Set OFF
If Output Step10_Up = ON Then 20
If Output Step20_Up = ON Then 20
If Output Step40_Up = ON Then 40
If Output Step80_Up = ON Then 80
If Output Step100_ON = ON Then ON
If Output Step80_Dn = ON Then 80
If Output Step40_Dn = ON Then 40
If Output Step20_Dn = ON Then 20
If Output Step10_Dn = ON Then 20
Bookmarks