I have my ATK that I was running stand alone for about 7 months. No major issues expect a bad number one sensor . I have replace sensor and has been working fine. In the last week I hooked it up to a used Apex Classic. My issue is when I run in stand alone everything works ok but the moment I connect the bus port to the apex classic from the FMM module my ATK will not respond. I can see in my apex Fusion that the sensor's work but the pump will not turn on when the sensor is above the water or even when I switch to on in Apex Fusion. I have to unplug the USB port from the FMM and switch on in Fusion. I'm new to the game so I truly appreciate anyone advice. Thank you!
Sent from my SM-G955U using Tapatalk
Bookmarks