I want to setup an alarm so that if my ATO pump goes off due to running to long or due to running out of water it sends out an alarm after X amount of time.
The ATO is set to Auto and two sensors for high and low levels. I thought I could just set it to Outlet = OFF Then ON but that did not work the alarm staid on the entire time, how the pump if off when not in use.
I just thought about, maybe I can use the lower sensor instead, maybe defer 060:00 to give the ATO time to fill? Not sure if it will just wait 60 min before it sends the alarm even though the status of the sensor has already changed or after the defer if it will see the status change and go back to OFF?
Is anyone doing anything interesting for the ATO alarm or if you know what to do let me know please.
Bookmarks