Hello
I am confused about how to setup my vortechs in re: to anti sync. I was in fusion yesterday looking at the pump profiles via the "download schemes" link. I thought i would give this one a go
vortech1.JPG
I applied this profile to my left side vortech, changed "unknown" to my right side vortech and saved the profile. I then went into my right vortech and copied the profile to it. So now both pumps have the same profile and are anti-syncing each other
L-Vortech.JPGR-Vortech.JPG
The light on both pumps' controllers is orange, so i have 2 slaves and no master? I guess that is because i have them both set to anti-sync. Five of the speed LEDs are lit on each controller.
Having read these forums a bit now, it seems the scheme i have downloaded is only half a scheme ie their should be another profile for this one to anti-sync to?
Cheers
Bookmarks