I'm likely missing something really easy, but I have a question on my ATO. The delay works just fine to avoid the ATO turning on until the sump_low float stays in an on state for 5 minutes. However, I have it set (or rather trying to set) a min time of 10 minutes. This part is not working and the ATO pump turns off the moment the sump_low goes to an off state instead of running an additional 10 minutes. Thanks!
Fallback OFF
Set OFF
If Output Sump_Low = ON Then ON
If Output Sump_High = ON Then OFF
Defer 005:00 Then ON
Min Time 010:00 Then OFF
Bookmarks