Results 1 to 5 of 5

Thread: 1” return flow sensor stopped registering on fusion

  1. #1
    Frequent Visitor
    Join Date
    May 2017
    Location
    Lynn, MA
    Posts
    112

    1” return flow sensor stopped registering on fusion

    My return flow sensor stopped registering this morning. everything is running fine. FMM has a green light also.

    TIA!


    Sent from my iPhone using Tapatalk Pro

  2. #2
    New User
    Join Date
    Jul 2017
    Location
    Florida
    Posts
    3
    Mine has done this a few times since I've had it, I have to clean it and spin the wheel inside with a long brush . Then it works like it suppose to.

  3. #3
    Frequent Visitor
    Join Date
    May 2017
    Location
    Lynn, MA
    Posts
    112
    Quote Originally Posted by brianwb View Post
    Mine has done this a few times since I've had it, I have to clean it and spin the wheel inside with a long brush . Then it works like it suppose to.
    do you take it apart to clean inside?


    Sent from my iPhone using Tapatalk Pro

  4. #4
    New User
    Join Date
    Jul 2017
    Location
    Florida
    Posts
    3
    No I did not take it apart , I cleaned it with some hot water and a small brush thru the inside, the wheel started moving again. When I first started the wheel was not moving at all.

  5. #5
    Frequent Visitor
    Join Date
    Jun 2013
    Location
    So St. Louis....
    Posts
    124
    When it happens to me I normally take it apart, clean, and put back together. Only takes a few minutes to remove screws. Out of 6 flow meters I only have one that requires this often.

Similar Threads

  1. Question: Return Flow Sensor and Cor 15
    By BoredNuke in forum Misc Apex Usage & Programming
    Replies: 13
    Last Post: 01-29-2023, 15:44
  2. Help! 1" Flow sensor stopped working
    By frank@wall in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 28
    Last Post: 01-29-2023, 15:26
  3. Question: Return pump low flow alarm from FFM flow sensor
    By Cpage101 in forum APEX Fusion
    Replies: 3
    Last Post: 08-09-2019, 11:37
  4. Help! Flow sensor stopped working
    By Scubalens in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 2
    Last Post: 04-30-2019, 09:56
  5. 1/2" flow sensor just stopped working
    By Krazie4Acans in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 6
    Last Post: 05-03-2017, 04:20

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •