Hi there,
i have a question regarding my Tunze Setup. I have a Tunze Apex Control Cable connected to my two Tunze Stream 3. The Tunze Cable is connected to the L3/4 Port of the Apex Classic. Only one Pump seems to respond and Varies Speed depending on my programming. The other Pump always goes full speed when i connect the Tunze End of the cable. If i switch the Tunze cabel between the pumps the problems carries to the the other pump. Since the Tunze/apex cable is short i used a CAT5 cabel with an CAT6 coupling to connect. Any idea what i am doing wrong?
Regrads Johannes
Bookmarks