Hi I’m new to setting up the Apex. I’ve got my gravel heater cable plugged into outlet one but how do identify which outlet to program in Apex?
Hi I’m new to setting up the Apex. I’ve got my gravel heater cable plugged into outlet one but how do identify which outlet to program in Apex?
If you open the outlet page, there is a device field (also shown in the outlet while programming). These fields show the aquabus address or base first followed by the outlet number. The one circled for example is the 1st outlet on the EB832 that has aquabus address 2.
Sent from my SM-G965U using Tapatalk
My light is plugged into outlet three but outlet 1 is controlling it. Not sure what’s going on??
2C5C7B69-9E96-4608-A02C-03C010AD1D2A.jpgLights are being controlled by lights1 & plugged into 3rd outlet what am I missing?
So you are saying the light is physically plugged into outlet 3 and if you change the state of Light1_4_1 to manual ON or manual OFF the light is responding to those commands?
Sent from my SM-G965U using Tapatalk
Yes that exactly what I’m saying. I’ve taken a photo of the my EB6 the lights plug is the one with the two into one, socket three.8C410EB7-9DCF-4F68-AB48-1158CC5C3967.jpgJust to make it more confusing my iPad has put the photo on upside down.
Odd. Haven't seen that behavior before. I would contact support. If you have a 12V aux power supply, you could always plug that in, unplug the EB6, delete the module, and then plug it back in. Updating its firmware could potentially have a beneficial effect too.
Sent from my SM-G965U using Tapatalk
What is plugged into outlet 1?
Post the programming you have for outlet 1 and outlet 3.
Sent from my iPhone using Tapatalk
This the two programmes which are the same now because I was trying to control it with outlet three. Please let me know if anything looks incorrect. 43960E09-B39A-4CC1-9CF9-ADA254668251.jpg
Bookmarks