Results 1 to 2 of 2

Thread: 4mm ID tubing and Trigger dosing containers

  1. #1
    Regular Vistor
    Join Date
    Aug 2016
    Location
    Ocala, FL
    Posts
    37

    4mm ID tubing and Trigger dosing containers

    Any solutions to the mis-match? I cannot justify dumping the Trigger 1/4" dosing containers. This has held me back from getting the DOS. Just too much in the way of seconday costs.

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    You can use 1/4" tubing on the dos (as long as its thick walled) and you can use 4mm id tubing on 1/4" fittings.

    Sent from my SM-G965U using Tapatalk

Similar Threads

  1. Review My Program Stop DOS from Dosing when 2part containers are almost empty
    By rst in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 0
    Last Post: 10-24-2018, 05:28
  2. Replies: 5
    Last Post: 02-16-2018, 17:42
  3. Replies: 2
    Last Post: 06-09-2017, 19:09
  4. warning on dosing containers
    By rschneid in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 2
    Last Post: 03-08-2015, 10:24
  5. Dosing containers with bracket for float
    By LobsterOfJustice in forum The Neptune Café
    Replies: 4
    Last Post: 01-18-2015, 18:03

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •