I have been running this configuration for at least 6 months without issue. Over the last few days, I have noticed by ATK switch on the console turning itself OFF. It has done this in the past after the pump had run for more than 5 minutes so I switched it back on Auto.
Today I did the same when I saw it OFF and went to check to make sure it was running. It wasn't. So I switched the Outlet to ON.. Nothing.
Outlet says it is ON, PMUP isn't running. No clog, impeller looks fine. Only run in RODI water so no Kalk issues.
Here is my program for reference: Note, I did switch it to 10 min max run time to validate it wasn't going over the 5 minutes before I realized it was not running at all.
Fallback OFF
Set OFF
If Swx10_1 OPEN Then ON
If Swx10_2 CLOSED Then OFF
If Power Apex Off 005 Then OFF
When On > 010:00 Then OFF
Defer 000:15 Then ON
Defer 000:15 Then OFF
Min Time 060:00 Then OFF
Next steps in troubleshooting?
Bookmarks