Hi
I am currently connected via wired network. i was wondering if there is a way where by if the wired network stopped for any reason, Apex switch automatically to wireless ( I am using LTE wireless router as backup to wired network).
Hi
I am currently connected via wired network. i was wondering if there is a way where by if the wired network stopped for any reason, Apex switch automatically to wireless ( I am using LTE wireless router as backup to wired network).
Yes. There are instructions in the getting started
Sent from my SM-G965U using Tapatalk
Thank you.
maybe I missed it in my reading
will check it
I have checked getting started it talks about connecting Apex to either Ethernet or wireless
so if I am currently using Ethernet connection, I can configure the wireless to work as a backup to Ethernet without affecting all my setup using the procedure in getting started??
You can go to the Network setup page in Fusion, Enable and Configure your WiFi connection, reboot the Apex to test the WiFi, and then Disable the Wifi to get back to your cable connection.
Thanks rkpetersen
i will check it
Bookmarks