I'm confused .. i'm trying to input test results for alk cal and mag into fusion ...
it says "reading" does that mean i input the number where the plunger is or am I inputting the actual amount of titrant used.
see example below
RSmeasurement.JPG
I'm confused .. i'm trying to input test results for alk cal and mag into fusion ...
it says "reading" does that mean i input the number where the plunger is or am I inputting the actual amount of titrant used.
see example below
RSmeasurement.JPG
With Red Sea kits you enter the amount used.
In the screen shot you took you entered it right.
I think the wording "reading" is very misleading in the way's it's presented.
I propose the verbiage get's changed to Amount of titrant used
The reading you enter in APEX Fusion is whatever the test kit instructions say to use, which in this case is the amount used, not the amount remaining in the syringe.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Yes, be sure you enter for "Reading" what the end result of how much titrant you used.
Bookmarks