Here is my design for a mount/magnet holder to keep the WAV Magnets in place. This is handy when I clean my WAV Pumps. If your WAVs are on the back of your tank, like mine, it can be a pain to take the WAV pumps out to clean them. This holder keeps the (outside the tank) magnets in place while you clean the WAV pumps. Since the pumps are on the back wall, nobody sees these brackets, and I can remove the WAV Pumps, clean them, and put them back in place, without having to worry about the outside magent falling down behind the tank. I print in PLA (As no part of them touches the water in my tank) with supports.
There are 2 mounts and an extension. One mount holds the magnet in a way that the WAV can be mounted vertical (So that it can be adjusted up or down 20 degrees). The other mount holds the magnet so that the WAV can be mounted horizontally (So that it can be adjusted side to side 20 degrees). Print out the mount you want and the extension, and zip tie them together so that they hold the pump at the correct height.
Bookmarks