Results 1 to 3 of 3

Thread: Can you program an outlet based on DOS state?

  1. #1
    Frequent Contributor SuncrestReef's Avatar
    Join Date
    Feb 2018
    Location
    Beaverton, OR
    Posts
    3,105

    Can you program an outlet based on DOS state?

    I am using a DOS for 2 part. I want to run a small powerhead in my sump only when the DOS is actually pumping, but I can't figure out if it's possible. I tried this, but the powerhead just stays on even after the DOS stops:

    Fallback OFF
    Set OFF
    If Output DOS_ALK = ON Then ON
    If Output DOS_CAL = ON Then ON

    Any ideas?

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Not if you're using the wizard. The DOS is ON as far as the outlet programming is concerned while it's running the wizard data.

    Sent from my SM-G965U using Tapatalk

  3. #3
    Frequent Contributor SuncrestReef's Avatar
    Join Date
    Feb 2018
    Location
    Beaverton, OR
    Posts
    3,105
    OK, that's what I figured. Instead I'll just program the powerhead to run during the hours where the DOS will be active.

    Thanks.

Similar Threads

  1. Question: program based on DOS pump activity during AWC
    By tenurepro in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 7
    Last Post: 03-26-2019, 06:36
  2. Programming based on BoB switch state
    By Reef_Paddy in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 2
    Last Post: 02-08-2016, 13:32
  3. Replies: 1
    Last Post: 07-29-2015, 05:28
  4. Outlet state ordering
    By hilgert in forum Apple iOS App for APEX Fusion
    Replies: 3
    Last Post: 02-26-2014, 17:56
  5. Question: Outlet State Timer?
    By jimsflies in forum Misc Apex Usage & Programming
    Replies: 3
    Last Post: 03-11-2013, 11:03

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •